Tools & Equipment Q&A

Question 1

Karen Dervan

I had my Sheen gun delivered today. I'm trying everything but the wick will not light. There is sufficient pressure (5psi) and I can hear and see the fuel being released to the coil. But the wick will not light, no matter what I do. Any ideas? You've to c...

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 2

Glenn Casey

The washer on the pump seems a little to small and takes a lot of pumping to build up pressure.is it possible to tighten it up to make it spread and fill the tube?

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 3

Freda Johnston

How do you decide what hoe head size is best. Thank you

Asked 5 years ago 1 answer

Garden Supplies > Tools & Equipment > Weeding > The Stirrup Or Oscillating Hoe

Question 4

Victoria bacon

I am trying to get two replacement heads and screws for my two golden gark rakes. I have one which is whole but the other two have broken prongs. Any suggestions. It seems such a waste to have to throw them away.

Asked 8 years ago 1 answer

Golden Gark Multipurpose Garden Tool

Question 5

Guest

X300

Asked 7 months ago 1 answer

Sheen X300 Flamegun

Question 6

Roisin Browne

Hi,I have a bramble problem in my garden and want to clear a large area ( approx 30 m by 8 m)of a rock garden. It is covered in brambles and valerian abs I want to clear the area we’ve done this by hand a few times but it grows back as we didn&rsqu...

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 7

Cecilia

Hi, we want to finish a wooden fence by torch burning (shou sugi ban). Would this flame-gun do the job?

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 8

Guest

No pressure after pumping Sheen burner

Asked 1 year ago 1 answer

Sheen X300 Flamegun

Question 9

Conor

I bought a Falci hoe. It comes with the head separate to the handle. How do I attach them? Just drive it down? Nail it? Screws?Thanks!

Asked 3 years ago 1 answer

Garden Supplies > Tools & Equipment > Digging > Falci Hand Forged Heavy Duty Garden Hoe

Question 10

Jennifer

Do you have any stockists in Canada or, alternatively, do you deliver to Canada? Thanks.

Asked 6 years ago 1 answer

Golden Gark Multipurpose Garden Tool

Question 11

Mark

What are the cleaning and maintenance tools?

Asked 6 years ago 1 answer

Sheen X300 Flamegun

Question 12

Robin

How long is the spade, ie blade and shank and handle?

Asked 4 years ago 0 answers

Greenman Half Brite Digging Spade

Question 13

Ros

Would I be able to buy just the wooden handle please? It’s for a craft project.

Asked 5 years ago 1 answer

Greenman Half Brite Digging Spade

Question 14

Tom Fallon

Hi.I am looking for a long handled fork for digging allotment beds.Can you recommend a good quality long handled fork.RegardsTom Fallon

Asked 8 years ago 1 answer

Garden Supplies > Tools & Equipment > Digging > Greenman Stainless Steel Border Fork

Question 15

Oliver Kavanagh

No Title

Asked 8 years ago 0 answers

Garden Supplies > Tools & Equipment > Digging > Greenman Stainless Steel Border Fork

Question 16

Mary (Mary Cox)

I have a large red bricked patio area - would the flame scorch, blacken or crack the bricks, which are factory made and not stone?

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 17

Marie

Hi Niall, can you tell me if I can use the x300 flame gun on asphalt to kill mossThanksMarie

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 18

Kay O'Dea

Hi Niall,Just wondering if you have suggestions as to what container works well for storing the Kerosene in - I'm presuming the usual petrol containers would be too small.

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 19

marie lafferty

Hi can you tell me what is the diameter of the flame funnel. also in the image it shows it as quite a Hairy flame, does it become more controlled the lower you go to the ground.thanks in advance

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 20

david gilmore

where can i purchase the fire retardant at flame nose rear?

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 21

Paul

Hi, after turning off the burner do you release the air from the tank

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 22

Damien Duffy

Sheen X300 Flamegun when will this be available again i am looking to buy one ASAP?

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 23

Terry Hopp

Hello, I am interested in purchasing a Sheen x300 flame gun for my husband for Father's Day. Can you tell me when it will be back in stock?

Asked 3 years ago 1 answer

Sheen X300 Flamegun

Question 24

Todd Sullivan

Hi, I have a roll of Mypex Weed Control Landscape Fabric that I purchased from yourselves. I want to make holes in it to plant flowers. Would this be good at making the holes? I watched the video, and it looks to burn very hot with a large flame, maybe...

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 25

John Browne

Is it ok to use this on an old stone wall, to help kill off ivy? Question really is about using it in a more horizontal position, rather than pointing at the ground.

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 26

Bill Taylor

I was wanting to order the flame gun; but I noticed that it is currently out of stock. Do you know when it will become available again? Also I wanted to know whether the hood is advisable particularly when working near buildings. Also is it OK on mono blo...

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 27

Richard

Removing couch grass and Bindweed? Hi, do you think this Flamegun will work to remove couch grass and bindweed as I have this all over a new garden I have?

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 28

Georgie

Hi There - Does the inferno kill horsetail weed? Just been out with my bunson burner to try and it seemed to take massive offense to the heat and melted. Pay this might work! Thank you!

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 29

Bushy

Hi guys, my wife has developed an allergy to razors, and she is getting very untidy down below. Would this weed burner get her back on track?

Asked 4 years ago 0 answers

Sheen X300 Flamegun

Question 30

Jim Foran

Hi, Interested in this for week control. Where would you source parrafin/kerosene in the Sligo area for use in the Flamegun

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 31

Walter van der Merwe

Hi Andrew, I saw your review on the Sheen flame gun, would it be as effective on briars new growth, I do not like spraying and hopefully the flame gun will be a way around it.Thank you.Regards,Walter

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 32

Jane

Would this work on a large area of tarmac or would it melt it?

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 33

VINCENT

Is it effective on ground ivy?

Asked 4 years ago 1 answer

Sheen X300 Flamegun

Question 34

Kathy clark

Can it be used on hogweed?

Asked 5 years ago 1 answer

Sheen X300 Flamegun

Question 35

Olive

Hi Niall,I'm looking to clean up a gravel driveway without chemicals and this looks a plan. Do you think it could take care of brambles as well?

Asked 5 years ago 1 answer

Sheen X300 Flamegun

Question 36

Hawt Cwnt

You say in the description it kills weeds off patio and paving. But won't it blacken and/or crack the paving stones from the fire and the heat?

Asked 5 years ago 1 answer

Sheen X300 Flamegun

Question 37

wendie

Hi I'm interested in purchasing this but just wanted to know can you kill weeds in grass/lawn area without killing grass? Also wondering if you have a lot of area to do and need to refill tank is it safe to do while still hot after turning off? Thanks

Asked 5 years ago 1 answer

Sheen X300 Flamegun

Question 38

Nichola Fletcher

I've been toying with buying one of these. As well as gravel areas etc, we have a gravel garden with precious plants in it but quite spaced out till they expand. I can see the extent of the flame in the video & pictures, but how far away from plants y...

Asked 5 years ago 1 answer

Sheen X300 Flamegun

Question 39

Andy

Can it be used on tarmac drive ways for moss removal and weeds

Asked 6 years ago 1 answer

Sheen X300 Flamegun

Question 40

Maria stack

I bought a flamegun from you 2 weeks ago. It's great. Do you stock the wheels and flame shield?

Asked 6 years ago 1 answer

Sheen X300 Flamegun

Question 41

Damian

Hi,Would there be any issue ordering one of these and bringing it (unopened or used) onto a plane (Ryanair)as part of the carry-on luggage?

Asked 6 years ago 1 answer

Sheen X300 Flamegun

Question 42

Fiona Neill

I would like to order one of these but live on Isle of Bute Scotland. How much would delivery be for this area?

Asked 6 years ago 1 answer

Sheen X300 Flamegun

Question 43

Jenny

Can it be shut off quickly?

Asked 6 years ago 1 answer

Sheen X300 Flamegun

Question 44

Richard finn

Hi is this item in stock.i live in county offaly

Asked 4 years ago 1 answer

Cliplift Hydraulic Lawn Mower Tilt 300kg

Question 45

Dave Hunt

Will 15inch wheels fit or are they too small

Asked 5 years ago 1 answer

Cliplift Hydraulic Lawn Mower Tilt 300kg

Question 46

Gabe

Does rear wheel width matter provided overall wheel base is within your specification?I have wide chevron tread tyres fitted to give wet grass grip

Asked 5 years ago 1 answer

Cliplift Hydraulic Lawn Mower Tilt 300kg

Question 47

Philip Holloway

Is this lift in stock? Or when will it be in stock?Thanks

Asked 3 years ago 1 answer

Cliplift Magnum Hydraulic Lawn Mower Tilt 500kg

Question 48

Gabriel Moran

Will this lift be back in stock soon

Asked 4 years ago 1 answer

Cliplift Magnum Hydraulic Lawn Mower Tilt 500kg

Question 49

Gabriel Moran

Is the 127cm from outside to outside of wheel

Asked 4 years ago 1 answer

Cliplift Magnum Hydraulic Lawn Mower Tilt 500kg

Question 50

Guest

What is the ideal temperature for the soil for most seeds to germanate and develop?

Asked 3 years ago 1 answer

Bio Green Digital Thermostat - Thermo 2

Tools & Equipment Q&A

Activity timeframe

Browse by Category

Browse by Category

Tools